Three‐dimensional color prediction modeling of single‐ and double‐layered woven fabrics

In this research, the three‐dimensional structural and colorimetric modeling of three‐dimensional woven fabrics was conducted for accurate color predictions. One‐hundred forty single‐ and double‐layered woven samples in a wide range of colors were produced. With the consideration of their three‐dimensional structural parameters, three‐dimensional color prediction models, K/S‐, R‐, and L*a*b*‐based models, were developed through the optimization of previous two‐dimensional models which have been reported to be the three most accurate models for single‐layered woven structures. The accuracy of the new three‐dimensional models was evaluated by calculating the color differences ΔL*, ΔC*, Δh°, and ΔE_CMC(2:1) between the measured and the predicted colors of the samples, and then the error values were compared to those of the two‐dimensional models. As a result, there has been an overall improvement in color predictions of all models with a decrease in ΔE_CMC(2:1) from 10.30 to 5.25 units on average after the three‐dimensional modeling.     

Automated network management and configuration using Probabilistic Trans-Algorithmic Search

Online configuration of large-scale systems such as networks requires parameter optimization within a limited amount of time, especially when configuration is needed as a response to recover from a failure in the system. To quickly configure such systems in an online manner, we propose a Probabilistic Trans-Algorithmic Search (PTAS) framework which leverages multiple optimization search algorithms in an iterative manner. PTAS applies a search algorithm to determine how to best distribute available experiment budget among multiple optimization search algorithms. It allocates an experiment budget to each available search algorithm and observes its performance on the system-at-hand. PTAS then probabilistically reallocates the experiment budget for the next round proportional to each algorithm’s performance relative to the rest of the algorithms. This “roulette wheel” approach probabilistically favors the more successful algorithm in the next round. Following each round, the PTAS framework “transfers” the best result(s) among the individual algorithms, making our framework a trans-algorithmic one. PTAS thus aims to systematize how to “search for the best search” and hybridize a set of search algorithms to attain a better search. We use three individual search algorithms, i.e., Recursive Random Search (RRS) (Ye and Kalyanaraman, 2004), Simulated Annealing (SA) (Laarhoven and Aarts, 1987), and Genetic Algorithm (GA) (Goldberg, 1989), and compare PTAS against the performance of RRS, GA, and SA. We show the performance of PTAS on well-known benchmark objective functions including scenarios where the objective function changes in the middle of the optimization process. To illustrate applicability of our framework to automated network management, we apply PTAS on the problem of optimizing link weights of an intra-domain routing protocol on three different topologies obtained from the Rocketfuel dataset. We also apply PTAS on the problem of optimizing aggregate throughput of a wireless ad hoc network by tuning datarates of traffic sources. Our experiments show that PTAS successfully picks the best performing algorithm, RRS or GA, and allocates the time wisely. Further, our results show that PTAS’ performance is not transient and steadily improves as more time is available for search.     

饱和尾粉砂动孔隙水压力发展特性试验研究

采用动三轴仪对内蒙古某尾矿库尾粉砂进行了动强度试验,研究了围压、相对密实度及固结比对动荷载作用下尾粉砂中孔隙水压力发展特性的影响。研究结果表明,随着固结比、相对密实度、围压的增大,动荷载作用下饱和尾粉砂孔压增长曲线形状由陡峭转变为平缓。随着围压及固结比增大,试样动力破坏形式从以孔压值为主要表征指标的液化破坏,转化为以动剪应变为主要破坏形式的软化破坏。动荷载作用下发生液化破坏的饱和尾粉砂孔压增长过程分可为初始增长阶段、稳定增长阶段和快速增长至破坏阶段,孔压增长曲线表现为明显的反S型,本文采用双对数函数对该试验孔压增长曲线进行拟合,结果表明该模型可以较好地模拟尾粉砂在动荷载作用下的孔压发展规律。     

甲基氯硅烷精馏流程的模拟与优化

采用Aspen plus软件对工业七塔精馏过程进行全流程建模与模拟，优化工艺参数，研究了新的精馏节能工艺。对一甲塔等7个精馏塔采用双因素水平的灵敏度分析，考察了塔釜采出率、回流比、进料位置和塔顶压力对产品浓度和热负荷的影响，确定一甲塔最优的工艺参数：塔釜摩尔采出率为0.92，摩尔回流比为130，塔顶压力为0.18 MPa，总理论板数为400，在210块理论板位置进料。在此基础上，针对高能耗的脱高塔/脱低塔，模拟研究了双效精馏新工艺，新工艺可节省39.70%的年总成本；针对一甲塔模拟研究了热泵精馏新工艺，新工艺可降低41.42%的年总成本。     

Note of clarification on Scholten and Sherman (2006): Erratum.

Reports an error in "Tradeoffs and Theory: The Double-Mediation Model" by Marc Scholten and Steven J. Sherman (Journal of Experimental Psychology: General, 2006 May, Vol 135[2], 237-261). This article was inadvertently printed with the incorrect title. The original title was "Tradeoffs and Conflict: The Double-Mediation Model." This title highlights the relation between tradeoffs and conflict as investigated by the authors and accounted for by their model. However, readers are asked to refer to the article by the title with which it was printed to facilitate its retrieval.. (The following abstract of the original article appeared in record 2006-06642-006.) Most theories of decision making suggest that, when options imply tradeoffs between their attributes, conflict increases as tradeoff size increases, because greater sacrifices are to be incurred in choosing one option instead of another. An alternative view is that conflict decreases as tradeoff size increases, because stronger arguments can be made for any decision. The authors propose a unified model, the double-mediation model, which combines the mediating effects of sacrifice and argumentation. Our model generally predicts an inverse U-shaped relation between tradeoff size and conflict. Results support this prediction. Also, when the decision situation increases the mediating effect of sacrifice relative to that of argumentation, the relation between tradeoff size and conflict changes in an upward direction; conversely, when the decision situation increases the mediating effect of argumentation relative to that of sacrifice, the relation changes in a downward direction. Results support these predictions as well. Commonalities and differences between our model and other formulations are discussed. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

双排桩门架—锚杆新型组合支护体系的应用研究

本文分析了双排桩门架支护结构的受力机理。针对工程实际进行变形分析,提出增设锚杆形成锚杆———双排桩门架式组合支护体系的方法,并与监测数据对比、验证。     

300 m级高拱坝设计与施工三维可视化仿真研究

双曲拱坝的C2连续曲面的三维模型表达困难,以双曲拱坝函数方程为基础引入CATIA三维软件,实现交互式设计和分析。同时,完成双曲拱坝细部模型的基于规则的智能化设计。基于大坝详细设计的三维成果,利用组件技术对模型数据进行提取和利用,制定施工方案并进行施工方案的动态可视化仿真。     

典型电子现金系统的分析及其安全需求

文章设计了一种电子现金系统,关键是对安全性、效率、成本等进行综合考虑。从这些方面入手,论文分析了三种典型的电子现金系统—D.Chaum方案、S.Brands方案和T.okamoto方案。然后,结合匿名通信协议,提出如何更好地满足顾客利用公开网络进行安全通信的需求。     

LD端面抽运掺Yb3+双包层光纤激光器自脉动行为的实验研究

本文对连续波半导体激光器端面抽运的Fabry-Perot腔掺Yb3 双包层光纤激光器的自脉动输出行为进行了研究．发现低Q值腔光纤激光器具有两种形式的自脉动输出，一种是饱和吸收被动调Q产生的自脉冲,另一种是与光纤中的受激Raman散射(SRS)效应相对应的阵发性巨脉冲．通过提高光纤激光器谐振腔的Q值并选择合适的抽运功率，可以有效地减小输出功率的自脉动，获得稳定的连续波激光输出．     

数字下变频器GC1012B原理及配置方法

数字下变频技术是软件无线电的一项核心技术,其性能的好坏直接影响数字接收机的精度。GC1012B是美国TI公司推出的新型数字下变频器。文中从GC1012B的结构特点和内部功能框图出发,分析其工作原理,并介绍GC1012B几个主要寄存器的配置方法,从而实现对频率、滤波模式、增益大小等参数的设置。最后给出了一个具体配置实例作为参考。